New Arrivals

Designed to add Reverb to music and recordings using a home stereo system. Built in Japan in the 1970s, this is a preamplifier with stereo line inputs, and a mic input. It has a pair of tape monitor loops, and outputs for Rear outputs when used in 4 channel mode.

These boards were removed from working machines that were missing parts. This board contains all of the relays, fuses, speed selection and timing control circuits for the MX5050BII machines. It is mounted behind the rear cover. It also bears the Otari number: PBA171E

Apple Macintosh Quadra 700, w Apple KB and Mouse, works fine. Internal checked for leaking battery and capacitors, everything is clean with no signs of corrosion.

This unit was removed from a non-functioning (defective power supply) TOA powered mixer. The module is very clean, and was operational before the mixer was pulled from service.

These were removed from a non-functioning (defective power supply) TOA powered mixer. These modules are very clean, and were operational before the mixer was pulled from service.

The Capstan motor and PCB control from an Otari MX5050 quarter inch machine. These motors were tested prior to removal from the various machines. No warranty or guarantee on any motor sales.

An octal plug in transformer for the Dukane Model 1E460A powered PA amplifier. These have been tested for continuity as per the pinouts.

Removed from working frames, 2 x FMV-564/XMT-L1-ST-IC Transmitters, and 2 x FMV-564/RCV-L1-ST-IC Receivers. Untested, working when removed, sold AS IS, no warranty, guarantee or returns. Price is for the lot of 4 units.

Fender Princeton Reverb, August 1967 issue. The amplifier works fine, including reverb and vibrato. It's quiet and was repaired around 1995. See details below, Local pickup only.

A single rack unit Break out box, with 4 12 pin MALE Hirose inputs, each Hirose is wired to 3 BNCs (Y, R-Y, B-Y) Channel 4 has an additional 12 pin Female Hirose Dub output. No brand anywhere on the box. The 12 Pin Male Hirose connector is the same type used on early Sony BVW style Betacam machines.

Boxed new old stock Eico meter for Electronic Volt- Ohmmeter. Four Scales for Ohms, DC volts, AC RMS volts, with Peak to Peak and RMS markings on all voltage scales.

Male Kings Triax connectors, part number KP8050-002-000, removed from a corporate installation. These are bulkhead connectors, with solder termination on one side. Excellent condition, both the finish and connector body.

14 Pin Male to Female Sony VDC-C Type Equivalent Cable, 65 feet, orange jacket. Used, Good condition, untested, Sold As Is.

CCU's for use with a variety of Sony DXC series Cameras, including DXC-537,637, D30 & D35. Open to Offers on these Sony M7s, other models and manufacturers available. Please call.

These modules are used with Crown International's tape machines. This one matches the description for the RP-3 type that was used with the 800 series decks. This unit is untested, and being sold as is.

Ensoniq EPS-M Musician's Manual, Ensoniq EPS Advanced Applications Guide, fair to good condition. Some damage to front cover, pages are good.

RTS systems Power Supplies, grounded, with a 4 pin female plug. All have been tested on RTS 848 Master stations and are working. Please Read full description.

RTS Master station, works with as many as 24 stations, handling as many as 12 conversations at once. These have been powered up only, being sold for parts/repair. See full description.

A pair of Technics EAS-8P327A6 tweeters, in excellent condition. Price is for the pair.

Alignment gauges, scales, hand tools, special blocks for alignment of a variety of SONY VTRs. These tools are lightly used, many in the original case/box. A full list is in the description.

A Hickok Roll Chart for Tube Tester, with one tear that was repaired (taped) by a previous owner. Please see photos #4 & 5 for details.

Removed from a MagnaTech 2000 series dubber setup, this meter has been tested and has a working movement. All Sales are final!

A Garner CDS-2500A conveyor belt degausser, will erase Digital Video tapes, and media up to 2400 Oersted. Shipping by Buyer's arrangement only. Liquidating ALL inventory, Open to offers.

A wired remote from an American Concertone model 605 Reel deck, estimated length is 35 feet. This remote was included with the original 1960s machine but is untested.

An unboxed NOS RCA 810 tube, from all appearances this is unused. No marks on any of the pins and the elements show no signs of heat stress. Sold AS IS.

Selling parts from an untested Model 605 tube reel Deck. Please Note: All parts sales are final, all parts sold AS IS. If you have any questions don't hesitate to call or email for more information.

Selling parts from an untested Model 605 tube reel Deck. Please Note: All parts sales are final, all parts sold AS IS. If you have any questions don't hesitate to call or email for more information.

These are precision 75Ω Video delay lines with BNC jacks. Total Delay is 325nSec. There are 12 delay lines per frame, the frames are 5.25" (3 rack units).

These are precision 75Ω Video delay lines with BNC jacks. Total Delay is 325nSec. Price is for a single delay. For bulk purchases please call or email for a quote.

The Counter Assembly from a MagnaTech Electronics 2000 series 16mm dubber. In good condition.

The Sprocket gates from a MagnaTech Electronics 2000 series 16mm dubber. These are sold as a pair.

Main Sprocket assembly from a MagnaTech Electronics 2000 series 16mm dubber. Note there is some rust to the steel sprocket ring.

Idler Roller with Flywheel from a MagnaTech Electronics 2000 series 16mm magnetic tape dubber. Price is for ONE roller assembly and flywheel.

A set of Reel Spindles from a MagnaTech Electronics 2000 series 16mm magnetic tape dubber. Price is for the set.

A set of mono heads (Record and Playback) from a MagnaTech Electronics 2000 series 16mm magnetic tape dubber. Price is for the set.

A 4 track, 3 channel professional tape deck, dual speed, very good condition. With DOLBY NR.

These JVC CR850 machines were working when acquired but have not been recently tested. Sold As IS for Parts. Local pickup, or customer arranged shipping.

A 2" CRT tube manufactured by RCA, in the original box. Unable to test, the tube appears new. Sold AS IS.

An original Marantz Wood cabinet for all Marantz 22xx series receivers. VG condition. Last one we're likely to see.

A working 1950s Mono Altec HiFi tube amplifier. This amplifier and has been tested and is working well. Please read the full description. Selling As Is.

A Vintage Type 85. For Studio and live use, an excellent sounding Direct Box with balanced Mic Level output.

A Two piece Sony Laser disk recorder, LVR5000A Processor and LVR5000A Disk Recorder, both in Excellent condition, A Blank Disk and operating manual are included. For Local pickup. Please call for shipping requests.

Parts from Crown International (yes that Crown) Model 700 and 800 series quarter inch decks. Head stack removed from an 800 series, model LL802. Windings tested for continuity only. See full description.

Parts from Crown International (yes that Crown) Model 700 and 800 series quarter inch decks. Head stack removed from an 800 series, model LL822. Windings tested for continuity only. See full description.

An early backup drive from a DAW setup. It runs, but we're unable to test it due to a lack of any cartridges. Sold with cable and SCSI terminator.

An early Japanese built battery powered recorder that is extremely low tech. It works, recommended for the collector. See full description..

A remote rack mount panel for controlling the Grass Valley Proc amp, Control panel only. PN 3240 RMT CP.

These have been removed from a variety of Grass Valley Group (GVG) 19" rack frames containing Video and Audio Distribution cards. SOLD AS IS, no returns.

Empty reel for your 1/2" tape machine. This one is an Ampex 456 Reel with Later Rainbow label. Some reels are in boxes with significant wear. Some reels have residue from markers and labels.

Empty reel for your 1/2" tape machine. This one is a later Ampex 456 Reel. Some reels are in boxes with significant wear. Some reels have residue from markers and labels.